38.2.2 Setting up a FrameMaker MIF project

When you select FrameMaker MIF as the output type for a new project, the Set Up dialog shown in Figure 38-1 opens. Table 38-1 shows the corresponding settings in the configuration file. When you specify FrameMaker MIF as the output type, Mif2Go saves all the files in your FrameMaker document (including the book file, if you so specify) in MIF format, and stops there.

See also:

§3.4 Choosing project set-up options

Figure 38-1 Set Up FrameMaker MIF Project

 

Table 38-1 FrameMaker MIF set-up options and configuration settings

Set-up dialog	Configuration file
Option	Section	Setting	Default	Ref.
Make MIF for book file	[Setup]	MakeBookMIF=Yes	Yes	38.2.3
Use original extensions for MIF	[Setup]	OrigExtForMIF=Yes	Yes	38.2.6
Use following extensions: For MIF file(s) For book file	[Setup]	OrigExtForMIF=No FileSuffix=.any MIFBookSuffix=.any	Yes .mif .mif	38.2.6

Note:  When you click OK to dismiss the FrameMaker MIF Set Up dialog, and Notepad opens to show configuration settings based on your choices, do not be alarmed if you see settings that purport to make both file extensions .mif, even though you specified original extensions. A later setting overrides the earlier settings.

 

---