9.3.2 Choosing set-up options for an MS HTML Help project

When you select MS HTML Help as the output type for a new project, the Set Up dialog shown in Figure 9-1 opens. Table 9-1 shows the corresponding settings in the configuration file. You must edit the configuration file to specify additional options.

See also:

§3.4 Choosing project set-up options

§7 Producing on-line Help

Figure 9-1 Set Up MS HTML Help Project

$Set Up MS HTML Help Project\: choose MS HTML Help for a new project.$

Table 9-1 HTML Help set-up options and configuration settings

Set-up	Configuration file
Option	Section	Setting	Default	Ref.
Gen TOC	[MSHtmlHelpOptions]	ListType=Contents \| Both RefFileType=Body \| Full	Both Depends*	7.3.4.1 9.9.1
Gen IX	[MSHtmlHelpOptions]	ListType=Index \| Both RefFileType=Body \| Full	Both Depends*	7.3.4.1 9.9.1
Use FTS	[MSHtmlHelpOptions]	UseFTS=Yes	Yes	9.11
Use Alias	[MSHtmlHelpOptions]	MakeAliasFile=Yes	Yes	9.12.1.1
Compile:	[Automation]	CompileHelp=Yes	No	9.14
.hhp:	[MSHtmlHelpOptions]	HHPFileName=MyDoc.hhp	MyDoc.hhp	9.3.7
.hhp:	[MSHtmlHelpOptions]	DefaultChmFile=MyDoc	MyDoc	9.3.7
Title:	[MSHtmlHelpOptions]	HelpFileTitle=My Title	Your Title Here	9.3.5
Start:	[MSHtmlHelpOptions]	DefaultTopicFile=Filename	MyDoc	9.3.5
Map:	[MSHtmlHelpOptions]	CshMapFile=resource.h	resource.h	9.12.1.1
Overwrite .hhp	[MSHtmlHelpOptions]	WriteHelpProjectFile=Yes	No	9.3.9
* The default is Body for FrameMaker books, Full for single document files.

9.3.1 Creating an HTML Help project

9.3.3 Deciding where to locate configuration settings